#
Checks of prestressed structures NEN 6720 (esacd.04.03)

esacd.04.03

“Checks of prestressed beams” is an advanced module for users of modules for the calculation of prestressed beams (See "Calculation of prestressed structures") and construction stages (See "Construction Stages FEM"). Beams can be of any cross-section and can be modelled in frame-XZ or frame-XYZ projects. There is no difference between 2D and 3D-structures. The module can be used with or without the TDA (Time Dependant Analysis) module (See "TDA"). The graphical window provides an easy check of the cross-section response, cracks, shear forces, torsion, principal stresses and capacity. All the defined construction stages can also be easily taken into account. The development of concrete strength and stiffness over time is taken into consideration in the model. Additionally, the check of allowable concrete and tendon stresses and the shear in the construction joint can be performed.

Highlights |
---|

In combination with construction stages and time dependent analysis represents a unique tool for analysis of prestressed concrete structures. |

Check of shear stress between connection plane. |

Check of principal stresses. |

## Working with the prestress checks

The user works in a fully graphical environment. After a successful calculation of a prestressed beam, the user can easily perform the required checks for individual construction stages. Thus, the check can be performed for any time instant of the span of the structure. For instance, the required reinforcement can be determined at the ultimate limit state. The calculation of longitudinal reinforcement takes into consideration the user-defined tendons/strands and soft steel reinforcement.

All data are clearly displayed. The check of the cross-section (strain, stress, force) has its own tab-page for internal forces resulting from (1) prestressing (primary/secondary), (2) dead and (3) life load.

It is even possible to perform the check of individual tendons, strands, reinforcement bars or concrete fibres.

Aging of young concrete is properly applied in the model, i.e. the concrete strength and stiffness depends on the time of casting.

The loads, strains, stresses and internal forces for uni-axially and bi-axially loaded cross-sections can be reviewed in a 2D or 3D graphical window.

Both initial and resultant state of the stresses, strains, etc. can be evaluated. The initial state is the state of the cross-section in which all dead loads including prestressing have been applied; the resultant state is the state of the cross-section in which all loads (dead and live loads including prestressing) have been applied. The operating stress in the prestressed tendons/strands is the stress including the losses due to creep, shrinkage and relaxation. Additionally, the losses due to elastic deformation are taken into account.

The moment capacity of the whole beam can be calculated for the resultant vector moment of My and Mz - the moment around y-axis and z-axis respectively. This capacity can be easily compared to the governing forces.

The capacity of a single section can be checked using the interaction diagrams of N, M_{y} and M_{z}.

The allowable stresses are checked according to clause 8.1.7 and 8.7.4. The influence of environmental classes, soft steel reinforcement amount and location of the prestressing reinforcement can easily be verified for individual construction stages.

## Conclusion

The module “prestress checks according to NEN 6720” is an easy-to-use tool for engineers who need to check reinforced, pre-tensioned beams according to the ultimate and serviceability limit state. There is no difference between uni-axial or bi-axial bending. All construction stages can easily be respected. The model takes into account the rheological aging (development of concrete strength and stiffness over time). The program operates easily and intuitively. The graphical output helps the engineer gain an insight and allows him to come to a more efficient design. The regenerated document bundles the calculation results and provides a sound and clear graphical output.

29/01/2015